We have a simple solution for those running Holley dual fuel rails to reduce the complexity and expense of running multiple fuel lines. Rather than running two -8 AN lines, you can now run a single -10 AN line to feed, return, and cross over between the two rails without sacrificing fuel flow.
We designed our Low Profile Dual Inlet Fuel Rail Adapter Kit for Holley Fuel Rails to improve firewall clearance while providing a cleaner engine bay, all while saving you money. The product allows you to simplify installation, improve the overall look, and cut down the cost of those expensive hose ends. Save yourself almost 3 inches of clearance compared to a standard O-ring, AN adapter, and 90-degree hose end.
The dual Fluorosilicone O-rings are resistant to alcohol, gasoline, and all grades of chemicals! The fuel rail fittings are slip fit and held in place with a stainless-steel locking clip. The Fuel Rail Adapter kit is pressure tested at over 150 PSI for hours! So you can breathe easy knowing it can handle the pressure (no pun intended). Using our Low Profile Dual Inlet Holley Fuel Rail Adapter, you will still need a 90-degree AN Fitting, whether a low-profile billet end or a standard.
Save money with our Low Profile Dual Inlet Holley Fuel Rail Adapter by running fewer AN fittings and hose ends! This not only cleans up your engine bay but simplifies the process! The kit includes a single pair with all necessary items to plumb two fuel rail ends. As a reminder, two pairs are needed to plumb all sides of the fuel rail.
Low Profile Dual Inlet Holley Fuel Rail Adapter Includes:
- 2 Hard Anodized Low Profile Dual Inlet Fuel Rail Adapters
- 4 Slip Fit Dual O-Ring Hard Anodized Fittings
- 2 Stainless Steel Locking Clips
- 12 Fluorosilicone O-rings
- All hardware required to install onto a Holley Dual Fuel Rail
